LED In-pavement Utility and Heliport Perimeter Light, Heliport Aiming Point Light FATO/TLOF Perimeter Light

 

A signalization FATO system (Final Approach and Take-Off area) is required for heliport with a big operation surface, for take off and helicoper Landing. The FATO lights, when they are present, is required if night operation are present. The system is composed by lights with white omnidirectional emission, located on the perimeter of heliport.

In some case, where the Landing are is reduced, the FATO area and the TLOF one are the same and the green lights are used.

The FATO area can be circular (in this case are required a minimum of 10 lights installed with a max distance of 5 meters one from the other) or square (in this case are required a minimum of 4 lights for each side, including the ones in the corners, and installed at a max distance of 50meters one from the others).




TECHNICAL FEATURES
  • Based on LED technology
  • White steady burning light
  • Intensity: 100cd
  • Long life time >10 years life expectancy
  • Low consumption
  • Lightweight and compact
  • IP68 protection degree
  • tested at wind over 240Kh/h (150MPH)
  • Easy to install
  • No RF-radiations
  • ICAO Certified
PARAMETER

  • Model No.: CM-HT12/D
  • Input Power: AC90-260V/6.6A
  • Power Consumption: ≤15W
  • Light Intensity: 100cd
  • Light Source: White LED
  • Emitting Color: White Ingress Protection: IP68
  • Environment Humidity: 0-100%
  • Altitude: ≤2500m
  • Operating temperature: -40℃~55℃
  • Wind Load:80m/s
  • Net Weight: 7.3kg
  • Size: Φ220mm×160mm


TEST VIDEO

CONTACT

Ms Sophia Guo | Overseas Business Development
Hunan Chendong Technology Co.,Ltd
T:+86-0731-85563165 85563265  | F: +86-0731-85563365 
P: +86-13929493960(Whatsapp)  | Skype:sophia.guo88
A:#4 Building, No.588 XinCheng Science&Technology Park, West of Yuelu Ave., Hi-Tech Development Zone,Changsha,China.
W:http://www.cdt-en.com/ | E: sophia@chendongtech.com

评论

此博客中的热门博文

Night Marking Red Obstruction Light System for Transmission Tower

High-voltage lines are major hazards for low-flying aircraft. Placing beacons on pylons is not sufficient to ensure safety due to the very long spans of cable. - Day Marking The warning ball for high voltage lines is a visual anti-aircraft protection for overhead wires and OPGW wires in high voltage transmission lines. It is recommended that in the case of a sphere with a diameter of 60 cm, the high-voltage line should be marked every 30 meters at the most. - Night Marking Conductor marking lights serve as a specialized category of aircraft warning lights specifically crafted for overhead power lines. In contrast to overhead wire markers that rely on daylight, conductor marking lights are designed to be visible during nighttime. These lights enhance the visibility of transmission line catenary wires in the vicinity of airports, heliports, and locations spanning across rivers. It is built around induction and takes its power from the current of the line, by the intermediary of a multi-winding coil directly installed within the beacon. This allows our system to adapt to every line voltage.

Overhead Wire Marker Fiberglass Aircraft Warning Sphere Day Marking Aerial Marker Balls for High Voltage Power Lines