Conductor Marking Light for High-Voltage Transmission Lines Power Supplied by Induction, Overhead Power Line Markers Transmission Line Aircraft Warning Conductor Marking Light Self Illuminated Power Line Marker

-






Conductor Marking Light for High-Voltage Transmission Lines Power Supplied by Induction, Overhead Power Line Markers Transmission Line Aircraft Warning Conductor Marking Light Self Illuminated Power Line Marker

For more details:
  • HUNAN CHENDONG TECH CO., LTD
  • Tel:  +0086-0731-85563265                                   
  • Fax: +0086-0731-85563365          
  • Skype:  sophia.guo88
  • Phone/WhatsApp:  +0086-13929493960  
  • Email:  sophia@chendongtech.com                        
  • Website:  http://www.cdt-en.com/   


ABOUT - CONDUCTOR MARKING LIGHT

Conductor marking lights are a particular type of aircraft warning lights designed for overhead power lines. They are visible at night, unlike overhead wire markers which rely on daylight. It is built around induction, it takes its power from the current of the line, by the intermediary of a multi-winding coil directly installed within the beacon. This allows our system to adapt to every line voltage.

Conductor marking lights increase the night conspicuity of transmission line catenary wires near airports, heliports, across rivers. Lamps mark and light overhead power lines support structures (towers) as well as high voltage transmission line catenary wires. It is one assembly light with multi-LEDs technology. Dedicated to the beaconing of high voltage lines, it is a long-life system (100,000 hours). Its compact design and lightweight allow the quickest and easiest installation on the market.

APPLICATION - CONDUCTOR MARKING LIGHT

Our induction beacon complies with the ICAO regulations (Annex 14, chapter 6) and is used as a conductor marking light for High Voltage Lines.
For lines located near airport platforms, it is necessary to set up a marking every 70 meters, otherwise, every 105 meters is enough. Nonetheless, in both cases, the first beacon must be within 10 meters of distance from the closest pylon.

TECHNICAL CHARACTERISTICS - CONDUCTOR MARKING LIGHT

Item Name
Conductor marking light
Model
CK-11
Voltage Lines
1V to 500kV
HV Current
15A-2000A
Operating Line Frequency
50Hz/60Hz
Light intensity
10cd/32.5cd
Life span
＞100,000 hours
Emitting color
RED
Power Consumption
5W
Overall size
350x281x190mm
Ingress protection
IP65
Operating temperature
-40℃～55℃
Net weight
4.1KG
Wind load
80m/sec.

DRAWING - CONDUCTOR MARKING LIGHT 

TEST - CONDUCTOR MARKING LIGHT 







INSTALLATION & TEST VIDEO - CONDUCTOR MARKING LIGHT 


评论

发表评论

此博客中的热门博文

Night Marking Red Obstruction Light System for Transmission Tower

-
图片
An overhead power line is a structure used in electric power transmission and distribution to transmit electrical energy along large distances. It consists of one or more conductors (commonly multiples of three) suspended by towers or poles. Red obstruction lights are used to increase conspicuity during nighttime. The red obstruction light system is composed of flashing omnidirectional lights (L-864) and/or steady-burning or flashing (L-810) lights. When one or more levels are comprised of flashing lights, the lights should flash simultaneously 1. Single Obstruction Light. A single red obstruction light (L-810) may be used when more than one obstruction light is required either vertically or horizontally, or when maintenance is needed, and can be installed within a reasonable time. Top Level. A single steady-burning light (L-810) may be used to identify low structures, such as airport instrument landing system buildings, as well as long horizontal structures, such as perimeter fenc...
阅读全文

High-voltage lines are major hazards for low-flying aircraft. Placing beacons on pylons is not sufficient to ensure safety due to the very long spans of cable. - Day Marking The warning ball for high voltage lines is a visual anti-aircraft protection for overhead wires and OPGW wires in high voltage transmission lines. It is recommended that in the case of a sphere with a diameter of 60 cm, the high-voltage line should be marked every 30 meters at the most. - Night Marking Conductor marking lights serve as a specialized category of aircraft warning lights specifically crafted for overhead power lines. In contrast to overhead wire markers that rely on daylight, conductor marking lights are designed to be visible during nighttime. These lights enhance the visibility of transmission line catenary wires in the vicinity of airports, heliports, and locations spanning across rivers. It is built around induction and takes its power from the current of the line, by the intermediary of a multi-winding coil directly installed within the beacon. This allows our system to adapt to every line voltage.

-
图片
High-voltage lines are major hazards for low-flying aircraft. Placing beacons on pylons is not sufficient to ensure safety due to the very long spans of cable. - Day Marking The warning ball for high voltage lines is a visual anti-aircraft protection for overhead wires and OPGW wires in high voltage transmission lines. It is recommended that in the case of a sphere with a diameter of 60 cm, the high-voltage line should be marked every 30 meters at the most. - Night Marking Conductor marking lights serve as a specialized category of aircraft warning lights specifically crafted for overhead power lines. In contrast to overhead wire markers that rely on daylight, conductor marking lights are designed to be visible during nighttime. These lights enhance the visibility of transmission line catenary wires in the vicinity of airports, heliports, and locations spanning across rivers. It is built around induction and takes its power from the current of the line, by the intermediary of ...
阅读全文

Overhead Wire Marker Fiberglass Aircraft Warning Sphere Day Marking Aerial Marker Balls for High Voltage Power Lines

-
图片
Overhead Wire Marker Fiberglass Aircraft Warning Sphere Day Marking  Aerial Marker Balls for High Voltage Power Lines  Warning sphere is used for warning aircraft pilots in daytime and nighttime, which is compliant with International Civil Aviation Organization (ICAO) recommendations annex 14 chapter 6. It can be used in overhead cable, guyed wire, especially in extra high voltage power transmission line, cross river power transmission line, cross road, bridge power transmission line and so on. It is made of high-grade polyethylene with the color of red, orange, white. Different colors' warning sphere should be displayed alternately. If there are many lines, warning sphere should be displayed on the highest line. It can resistant to corrosion, rust, water, dust, high temperature, can be used for long time. For more details: HUNAN CHENDONG TECH CO., LTD Tel:  +0086-0731-85563265                          ...
阅读全文