Tower beacon lights shall be fitted to towers in approaches to airports or in the normal flight paths of low flying aircraft or where helicopter traffic is present. The tower beacon lights shall conform to the requirements of the civil, military aviation and civil defense authorities and to the recommendations of the FAA and ICAO. Three layer lights would be placed on the top, at the lowest level of the conductor and in the middle.

 


Tower beacon lights shall be fitted to towers in approaches to airports or in the normal flight paths of low flying aircraft or where helicopter traffic is present. The tower beacon lights shall conform to the requirements of the civil, military aviation and civil defense authorities and to the recommendations of the FAA and ICAO. Three layer lights would be placed on the top, at the lowest level of the conductor and in the middle.


All components in the light system are designed for ease in maintenance and to provide the required performance as specified by ICAO for a period of at least three years without any maintenance. The power input for the light system are supplied through solar power with a backup battery for day/night time operation. The system are able to deliver the light output during day time, twilight and night time operations automatically.

For more details:
Website:http://www.cdt-en.com/
Email:sophia@chendongtech.com
Phone/WhatsApp:+86-13929493960

评论

此博客中的热门博文

Night Marking Red Obstruction Light System for Transmission Tower

High-voltage lines are major hazards for low-flying aircraft. Placing beacons on pylons is not sufficient to ensure safety due to the very long spans of cable. - Day Marking The warning ball for high voltage lines is a visual anti-aircraft protection for overhead wires and OPGW wires in high voltage transmission lines. It is recommended that in the case of a sphere with a diameter of 60 cm, the high-voltage line should be marked every 30 meters at the most. - Night Marking Conductor marking lights serve as a specialized category of aircraft warning lights specifically crafted for overhead power lines. In contrast to overhead wire markers that rely on daylight, conductor marking lights are designed to be visible during nighttime. These lights enhance the visibility of transmission line catenary wires in the vicinity of airports, heliports, and locations spanning across rivers. It is built around induction and takes its power from the current of the line, by the intermediary of a multi-winding coil directly installed within the beacon. This allows our system to adapt to every line voltage.

Overhead Wire Marker Fiberglass Aircraft Warning Sphere Day Marking Aerial Marker Balls for High Voltage Power Lines