Conductor warning light/power line marker/self illuminated power line marker/conductor marker light, warning light for conductor in high tension lines conductor

-

 














Conductor marking lights are a particular type of aircraft warning lights designed for overhead power lines. They are visible at night, unlike overhead wire markers which rely on daylight.

Conductor marking lights increase night conspicuity of transmission line catenary wires near airports, heliports, across rivers. Lamps mark and light overhead power lines support structures (towers) as well as high voltage transmission line catenary wires.It is one assembly light with multi-LED technology. Dedicated to the beaconing of high voltage lines,it is a long life system (100,000 hours). Its compact design and light weight allow the quickestand easiest installation on the market.

The ICAO compliant  Low Intensity Aircraft Warning light is powered by the magnetic field surrounding the power distribution wire and uses an electronic circuitintegrated in a compact clamp-on warning light. The operating principle is that of a Rogowski coil, similar to a currenttransformer. This solution is usually intended for medium and high voltage lines up to 500 kV. However inductivecoupling devices are able to work on any AC at 50 Hz or 60 Hz, from 50A up to 2000 Amps.


For more details:

  • Website:http://www.cdt-en.com/
  • Email:sophia@chendongtech.com
  • Phone/WhatsApp:+86-13929493960

评论

发表评论

此博客中的热门博文

Aircraft warning sphere warning marker balls for power lines

-
图片
Aviation obstruction marking sphere is designed to provide daytime visual warning or nighttime visual warning if comes with reflective tape, for electricity transmission line and overhead wire for aircraft pilots, especially cross river high voltage transmission lines. CDT power line marker ball is made of high-grade Fiberglass Reinforced Plastics(FRP), diameter of 600mm and 800mm are available to meet different customers’ needs.  A marking sphere should be of one color such as aviation orange, white and red. Generally, the marking spheres are placed on the highest line. Where there is more than one line at the highest level, white and red, or white and orange spheres should be displayed alternately. This alternating color scheme provides the most conspicuity against all back ground. PARAMETER Name Aerial Marking Sphere   Model CM-ZAQ Operation Visible Distance 1200 meters Flashing frequency 35KV-1000KV Conductor diameter 15-60
阅读全文

Building Light-Building Obstruction Light/Rooftop Heliport Lighting

-
图片
Buildings lighting Obstruction lighting solutions to be set at the top of buildings, and heliport lights, to be set around the runway in order to guide helicopters pilots. Lighting of buildings with heliports If the building has an elevated heliport, that is to say located on a raised structure on land, lighting marks have to be set around the runways to guide the pilots during take-off and landing. In the case of these elevated heliports, the Final Approach and Take-Off areas (FATO), and the Touchdown and Lift-Off areas (TLOF) are coincidental: only the TLOF runway matters. As a matter of facts, TLOF area should be lighted with TLOF perimeter lights: fixed omnidirectional green lights, inside the floor, or not higher than 25cm, uniformly spaced from 3 meters maximum. It will be possible to add floodlights to the perimeter lights, in order to identify better the heliport marks.  Lighting of buildings judged as air obstacles In t
阅读全文

L-806 L-807 LED Lighted Wind Cone with Obstruction Light/Illuminated Wind Sock

-
图片
A windcone is a carefully designed fabric cone that is mounted on a metal frame. This metal frame is attached to a vertical pole via a swivel that allows the fabric cone to rotate freely. The fabric cone must be designed to provide relative wind speed indication. A fully extended windsock indicates a wind speed in excess of 15 knots. An illuminated windcone must be powered in some manner. Common methods are with 120VAC/240VAC or 6.6Amp circuitry. Recent advances in both LED and solar power technology have allowed for the creation of reliable and compliant solar powered LED windsocks. Wind Direction Indicators or wind cones provide visual surface wind direction and velocity information to pilots in flight or on the ground at airport and heliports. We based our wind cone portfolio on FAA specifications OPTIONS  1. Fabric Windsock: Size 1- 1.2m length, 300mm in throat diameter and 150mm in trailing end diameter; Size 2- 2.4m length, 600mm in throat diameter and 300mm in trailing end diame
阅读全文