Solar Series FAA L810 / ICAO LIOL omni-directional, red, steady-burning led obstruction light, designed for marking tall structures such as buildings, towers, masts, cranes, meteorological towers, chimney and other airspace obstructions.

-

The Solar Series L810 omni-directional, red, steady-burning obstruction light is designed for marking tall structures such as buildings, towers, masts, cranes, meteorological towers, chimney and other airspace obstructions. The energy efficient LED light is paired with a compact solar engine that is capable of powering the light in almost any environment. As a virtually maintenance free solution, the Solar Series L810 provides years of reliable service and is a direct replacement for incandescent fixtures.

The Solar Series L810 light source is readily identified when using NVG equipment. It is available in single & double configuration and can be operated dusk to dawn or 24/7.

Spec
  • Model: CM-11-TZ
  • Operating Voltage: DC3.7V(Solar Powered)
  • Power consumption:≤5W
  • Flashing frequency: Steady-Burning
  • Light intensity:≥32.5cd
  • Life span:＞100,000 hours
  • Emitting color: RED
  • Beam angle:360° horizontal,> 10° vertical 
  • Overall size(mm):277mm×299mm×299mm
  • Installation size(mm):Ф90-130mm-4×M10
  • Ingress protection: IP65
  • Lightning protection level:10KA
  • Optical Sensitivity:100Lux
  • Operating temperature:-40℃～55℃
  • Net weight:4.5KG
  • Wind load:80m/sec.
  • Reserve: 3-5 days under cloudy/rainy

For more details: 
  • HUNAN CHENDONG TECH CO., LTD
  • Tel:  +0086-0731-85563265                                   
  • Fax: +0086-0731-85563365          
  • Skype:  sophia.guo88
  • Phone/WhatsApp:  +0086-13929493960  
  • Email:  sophia@chendongtech.com                        
  • Website:  http://www.cdt-en.com/    












评论

发表评论

此博客中的热门博文

Night Marking Red Obstruction Light System for Transmission Tower

-
图片
An overhead power line is a structure used in electric power transmission and distribution to transmit electrical energy along large distances. It consists of one or more conductors (commonly multiples of three) suspended by towers or poles. Red obstruction lights are used to increase conspicuity during nighttime. The red obstruction light system is composed of flashing omnidirectional lights (L-864) and/or steady-burning or flashing (L-810) lights. When one or more levels are comprised of flashing lights, the lights should flash simultaneously 1. Single Obstruction Light. A single red obstruction light (L-810) may be used when more than one obstruction light is required either vertically or horizontally, or when maintenance is needed, and can be installed within a reasonable time. Top Level. A single steady-burning light (L-810) may be used to identify low structures, such as airport instrument landing system buildings, as well as long horizontal structures, such as perimeter fenc...
阅读全文

High-voltage lines are major hazards for low-flying aircraft. Placing beacons on pylons is not sufficient to ensure safety due to the very long spans of cable. - Day Marking The warning ball for high voltage lines is a visual anti-aircraft protection for overhead wires and OPGW wires in high voltage transmission lines. It is recommended that in the case of a sphere with a diameter of 60 cm, the high-voltage line should be marked every 30 meters at the most. - Night Marking Conductor marking lights serve as a specialized category of aircraft warning lights specifically crafted for overhead power lines. In contrast to overhead wire markers that rely on daylight, conductor marking lights are designed to be visible during nighttime. These lights enhance the visibility of transmission line catenary wires in the vicinity of airports, heliports, and locations spanning across rivers. It is built around induction and takes its power from the current of the line, by the intermediary of a multi-winding coil directly installed within the beacon. This allows our system to adapt to every line voltage.

-
图片
High-voltage lines are major hazards for low-flying aircraft. Placing beacons on pylons is not sufficient to ensure safety due to the very long spans of cable. - Day Marking The warning ball for high voltage lines is a visual anti-aircraft protection for overhead wires and OPGW wires in high voltage transmission lines. It is recommended that in the case of a sphere with a diameter of 60 cm, the high-voltage line should be marked every 30 meters at the most. - Night Marking Conductor marking lights serve as a specialized category of aircraft warning lights specifically crafted for overhead power lines. In contrast to overhead wire markers that rely on daylight, conductor marking lights are designed to be visible during nighttime. These lights enhance the visibility of transmission line catenary wires in the vicinity of airports, heliports, and locations spanning across rivers. It is built around induction and takes its power from the current of the line, by the intermediary of ...
阅读全文

Overhead Wire Marker Fiberglass Aircraft Warning Sphere Day Marking Aerial Marker Balls for High Voltage Power Lines

-
图片
Overhead Wire Marker Fiberglass Aircraft Warning Sphere Day Marking  Aerial Marker Balls for High Voltage Power Lines  Warning sphere is used for warning aircraft pilots in daytime and nighttime, which is compliant with International Civil Aviation Organization (ICAO) recommendations annex 14 chapter 6. It can be used in overhead cable, guyed wire, especially in extra high voltage power transmission line, cross river power transmission line, cross road, bridge power transmission line and so on. It is made of high-grade polyethylene with the color of red, orange, white. Different colors' warning sphere should be displayed alternately. If there are many lines, warning sphere should be displayed on the highest line. It can resistant to corrosion, rust, water, dust, high temperature, can be used for long time. For more details: HUNAN CHENDONG TECH CO., LTD Tel:  +0086-0731-85563265                          ...
阅读全文