(1 DUTY + 1 STAND-BY) DUAL MEDIUM INTENSITY OBSTACLE LIGHT WITH SOLAR PANEL

Medium Intensity Solar Warning Lights (MIOL) with solar panel, multi LED type. In compliance with ICAO Annex 14 Type B, Type C and FAA L-864. This flashing red LED beacon obstruction light is the perfect solution for wind turbines, towers (cell/broadcast/other),buildings, and similar obstructions. Meets FAA and ICAO standards. Available with IR option for night vision. Easily retrofits to replace incandescent light.
Medium Intensity Obstruction Lights with Solar Panel have to be used where the obstacle is particularly large and the height of the surrounding soil is more than 45m and where the power supply does not arrive or where it is very weak.
This product is the ideal solution when looking for a reliable and high-quality solar system, to be installed in areas without power supply or when a temporary obstacle light system is required.
CDT Medium Intensity Obstruction Light with Solar Panel has been designed to be an assembly as compact as possible and easy to install.

Item
Parameter
Name
Dual Medium Intensity Obstacle Light with Solar Panel
ICAO Type
Medium Intensity Type B
FAA Type
L-864
Operating voltage
DC12V
Power consumption
≤10W
Flashing frequency
20~60times/min
Light source
Red LED
Light intensity
2000cd(±25%)
Lifespan
>100,000hours
Emitting color
Red

Beam angle
360° horizontal beam angle
≥ 3° vertical beam spread
Method of synchronization
GPS
Installation size(mm)
126mm-4×M11
Ingress protection
Ip65
Lightning protection level
15KA
Light controlled sensitivity
100Lux
Operating temperature
-40℃~55℃
Net weight
25kg
Wind load
80m/sec
Solar Panel Parameter
Voltage
16V
Working Voltage
18.3V
Power
48W
Lifespan of Solar panel
30 years
Working Current
3A
Using Rainy day OR Cloudy Day
25 days for working
Lead-acid Battery Parameter
Battery’s type
Lead-acid battery
Battery’s Item
KG12-24
Working Voltage
DC12V
Capacity(25℃)  10HR(10.8V)
24Ah
Internal Resistance(25℃)
7.0mΩ
Floating charge voltage(25℃)
13.60 to 13.80V -18mV/℃
Charging Voltage(25℃)
14.50 to 14.90V -30mV/℃
Maximum Current
13.75A
Short-circuit current
550A(5 sec.)
Life span
12 years

  

评论

此博客中的热门博文

Night Marking Red Obstruction Light System for Transmission Tower

High-voltage lines are major hazards for low-flying aircraft. Placing beacons on pylons is not sufficient to ensure safety due to the very long spans of cable. - Day Marking The warning ball for high voltage lines is a visual anti-aircraft protection for overhead wires and OPGW wires in high voltage transmission lines. It is recommended that in the case of a sphere with a diameter of 60 cm, the high-voltage line should be marked every 30 meters at the most. - Night Marking Conductor marking lights serve as a specialized category of aircraft warning lights specifically crafted for overhead power lines. In contrast to overhead wire markers that rely on daylight, conductor marking lights are designed to be visible during nighttime. These lights enhance the visibility of transmission line catenary wires in the vicinity of airports, heliports, and locations spanning across rivers. It is built around induction and takes its power from the current of the line, by the intermediary of a multi-winding coil directly installed within the beacon. This allows our system to adapt to every line voltage.

Overhead Wire Marker Fiberglass Aircraft Warning Sphere Day Marking Aerial Marker Balls for High Voltage Power Lines